Saturday, February 23, 2013

New Vacuum Pipe

The old vacuum pipe was too short and was tight over the top of the rocker cover, plus the ends were split. I ordered a new pipe and replaced it along with the rubber ends. As the new pipe is longer, I can decide on the best place to put it.

Short and sweet post, but at least it's sorted now.



Friday, February 22, 2013

New Wheel Nuts

I ordered new wheel nuts as the ones don't fit properly and were wearing the wheels. I ordered a set of nuts designed for Minilite wheels and they fit perfectly.


Short and sweet post, but there is not much else to write.


<Next Post> - 'New Vacuum Pipe'
<This Post> - 'New Wheel Nuts'
<Previous Post> - 'Engine Bay Tidy'

For updates, stick a 'Like' on Wayne's Mini Progress facebook page.

Sunday, February 17, 2013

Engine Bay Tidy

With the cooling system out at the moment, it seemed like an excellent opportunity to clean up the engine bay. Areas that were really letting the car down were the engine block, the inner wing where the radiator sits, the timing cover and a few of the ancillaries.

Bit grotty

Friday, February 15, 2013

Speedo Blunder


Recently, I was faffing about behind the instrument panel and while reassembling it, like a big ham fisted bufoon I managed to break the end off the speedo cable that attaches into the back of the speedo itself. There was a nylon square shaped sticky out bit, that I had not connected properly and snapped off!



Tuesday, February 12, 2013

Cooling\Heating System Overhaul - Part 2 - Heater Overhaul

Pressing on with the cooling/heating system overhaul, I now to turn my attention to the heater unit as it wasn't working as well as it should. I need to get it out of the car and taken to bits.



Sunday, February 3, 2013

Cooling\Heating System Overhaul - Part 1 - Radiator Overhaul

Having removed the radiator from the car, I started to clean it up and the paint on the top part of the radiator began to peal away to revealed a the rather nice brass finish underneath. It seemed criminal painting it again when the brass could be polished up so well. Seems like the plan has changed from painting to polishing.